Get Real 350-501 Exam Dumps [Jun-2022] Practice Tests [Q113-Q131]

Get Real 350-501 Exam Dumps [Jun-2022] Practice Tests

Last 350-501 practice test reviews: Practice Test Cisco dumps

NEW QUESTION 113
Drag and drop the multicast concepts from the left onto the correct descriptions on the right.

Answer:

Explanation:

Explanation
1: PIM-DM 2:IGMP 3:PIM-SM 3:shared tree 4:source tree

NEW QUESTION 114
After you analyze your network environment, you decide to implement a full separation model for Internet access and MPLS L3VPN services For which reason do you make this decision?

A. It enables you to choose whether to separate or centralize each individual service.
B. It requires only one edge router
C. It is easier to manage a system in which services are mixed
D. It enables EGP and IGP to operate independently

Answer: D

NEW QUESTION 115
Refer to the exhibit:

This output is included at the end of an output that was provided by a device using NETCONF.
What does the code show?

A. It shows the hostname of the device as rpc-reply
B. It shows that the running configuration is blank
C. It shows NETCONF uses remote procedure calls.
D. It shows that the full configuration is being modeled by VANG

Answer: A

NEW QUESTION 116
Refer to the exhibit:

A network engineer is implementing an OSPF configuration Based on the output, which statement is true?

A. OSPFv3 does not run for IPv4 on FastEthemet0/0 until IPv6 routing is enabled on the router and IPv6 is enabled on interface Fastfc.thernet0/0
B. IPv6 routing not enabled" is just an informational message and OSPFv3 runs for IPv4 on interface FastEthernet0/0 anyway
C. In the ospfv3 1 area 1 ipv4 command, area 0 must be configured instead of area 1.
D. OSPFv3 cannot be configured for IPv4; OSPFv3 works only for IPv6.

Answer: A

NEW QUESTION 117
Drag and drop the functionalities from the left onto the correct target fields on the right.

Answer:

Explanation:

NEW QUESTION 118
A network engineer must enable the helper router to terminate the OSPF graceful restart process if it detects any changes in the LS A.
Which command enables this feature?

A. nsf ietf helper disable
B. nsf Cisco helper disable
C. nsf ietf helper strict-lsa-checking
D. nsf cisco enforce global

Answer: C

NEW QUESTION 119
Refer to the exhibit:

After implementing a new design for the network, a technician reviews the pictured CLI output as part of the MOP.
Which two statements describe what the technician can ascertain from the ImpNull output? (Choose two.)

A. Label 3 is in use for the prefix displayed and will be part of the MPLS label stack for packets destined for 192.168.10.10
B. Label 0 is used for the prefix displayed and will be part of the MPLS label stack for packets destined for
192.168.10.10
C. Label 0 is used for the prefix displayed but will not be part of the MPLS label stack for packets destined for 192 168.10.10.
D. Ultimate Hop Popping is in use for the prefix displayed.
E. Penultimate Hop Popping is in use for the prefix displayed

Answer: A,E

NEW QUESTION 120
Refer to the exhibit.

AN engineer is configuring segment routing on an ISP to simplify traffic engineering and management across network domains. What should the engineer do to complete the implementation of segment routing?

A. Area authentication must be enable before segment routing will run.
B. OSPF must be configured with wide area metrics to support routing.
C. Area Authentication must be enable before segment routing will run.
D. The segment will run without any further configuration.

Answer: A

NEW QUESTION 121
Refer to the exhibit:

With which router does IOSXRV-1 have LDP session protection capability enabled but session hold up is not active?

A. 192.168.0.1
B. 192.168.0.5
C. 192.168.0.3
D. 192.168.0.4

Answer: C

NEW QUESTION 122
Refer to me exhibit. An engineer started lo configure a router for OSPF. Which configuration must me engineer perform on me router without changing any interface configuration so that the router establishes an OSPF neighbor relationship with its peer?

A. Option D
B. Option B
C. Option A
D. Option C

Answer: C

NEW QUESTION 123
Refer to the exhibit. An engineer is implementing BGP selective prefix suppression. The router must advertise only 10.16.4.0/24,10.16.5.0/24, and summarized route 10.16.0.0/21, and suppress
10.16.6.0/24. Which configuration must the engineer apply to the router?

Answer: D

NEW QUESTION 124
Drag and Drop Question
Drag and drop the BGP Best Path Algorithm rules from the left into the corresponding order of importance on the right.

Answer:

Explanation:

NEW QUESTION 125
An engineer applied a gRPC dial-in configuration on customer's router to provide connection multiplexing and two-way streaming. What does this configuration accomplish in a gRPC?

A. It specifies the encapsulation pushed by the client.
B. It specifies the encapsulation that is used tor daily and dial-out.
C. It specifies the encapsulation pushed by the server.
D. It excludes the encapsulation types gpbcompact and gpbkv.

Answer: C

NEW QUESTION 126
Refer to the exhibit.

An engineer needs to implement this QoS policy on customer's network due to ongoing slow network issues. What will be the effect on the network when the engineer implements this configuration?

A. Traffic that is identified in the ciscopolicy class map will be marked with IP precedence 1 when it enters the pos0/2/0/0 interface.
B. Traffic that is identified in the ciscotest class map will be marked with IP precedence 1 when it exits the poso/2/0/0 interface.
C. Traffic that is identified in the ciscotest class map will be remarked from IP precedence 1 to DSCP AF11 when it enters the pos0/2/0/0 interface.
D. Traffic that is identified in the ciscopolicy class map will be remarked from IP precedence 1 to DSCP AF11 when it exits the pos0/2/0/0 interface.

Answer: B

NEW QUESTION 127
Refer to the exhibit. If router A is the RP, which PIM mode can you configure so that devices will send multicast traffic toward the RP?

A. PIM-DM
B. PIM-SM
C. BIDIR-PIM
D. PIM-SSM

Answer: B

NEW QUESTION 128
What are two characteristics of MPLS TE turrets? (Choose two)

A. They require EIGRP to be running in the core.
B. The headend and tailend routes of the tunnel must have a BGP relationship
C. They are run over Ethernet cores only.
D. They use RSVP to provide bandwidth for the tunnel.
E. They are unidirectional

Answer: D,E

NEW QUESTION 129

Refer to the exhibit. When the Link Aggregation configuration router is running on Cisco IOS XR Software, which LACP interface configuration is needed to add the interface to the bundle?